with the collaboration of Iranian Society of Mechanical Engineers (ISME)

Document Type : Research Article

Authors

1 Mechanical Engineering of Biosystems Department, Ilam University, Ilam, Iran

2 Occupational Health Engineering Department, Hamadan University of Medical Sciences, Hamadan, Iran

Abstract

Introduction
The permissible exposure time to vibration for the operator is one of the key factors in maintaining the operator's health while optimizing machinery and equipment. The tractor studied was the ITM475, manufactured in Iran. The purpose of this study was to calculate the operator's permissible vibration exposure time while using the tractor to ensure the driver can maintain good bodily health.
Materials and Methods
In this study, experiments were conducted using a 3-axis vibration meter based on the ISO 2631 standard. The obtained data were analyzed through a factorial experiment using 18 treatments and 3 replications. The factors studied were engine rotation speed (at three levels of 1000, 1500, and 2000 rpm), road type (dirt and asphalt), and gear position (at three levels of 1, 2, and 3).
Results and Discussion
Various total vibration models were obtained for the tractor, and their determination coefficient varied from 90.11% for gear No. 3 on an asphalt road to 100% for gear No. 1 on an asphalt road and gear No. 2 on a dirt road. The maximum whole-body vibration, and consequently the minimum permissible exposure time, was observed for gear No. 3 at an engine rotation speed of 2000 rpm on a dirt road, which was 1.49 and 1.16 hours, respectively.
Conclusion
The maximum whole-body vibration experienced during an 8-hour tractor-driving session was measured at 0.85 m s-2. It is important to note that the permissible exposure time decreases as vibration levels increase, and it reaches a limit of 1.16 hours. To ensure drivers adhere to these permissible exposure times across various driving conditions, measures must be implemented to reduce tractor vibration and minimize its transmission to the driver. By reducing overall tractor vibration and minimizing its impact on the driver, it becomes possible to increase the permissible exposure time for drivers.

Keywords

Main Subjects

©2021 The author(s). This article is licensed under Creative Commons Attribution 4.0 International License (CC BY 4.0), which permits use, sharing, adaptation, distribution and reproduction in any medium or format, as long as you give appropriate credit to the original author(s) and the source.

  1. Ahmadi, Y., Ghamari, B., & Kheiralipour, K. (2017). Determination and Evaluation of seat vibration of ITM 800 Tractor. 11th Iranian National Congress on Mechanical Biosystems Engineering and Mechanization. September 12-14, Hamedan, Iran. (In Persian).
  2. Ahmadian, H., Hassan-Beygi, S. R., & Ghobadian, B. (2014). Investigating a power tiller handle and seat vibration on transportation mode. Agricultural Engineering International: CIGR Journal, 16(4), 194-206.
  3. Beigzadeh, Y. (2013). Investigation and analysis of vibration of motorised backpack sprayer. M.Sc. Thesis, Mechanical Engineering of Biosystems. Ilam: Ilam University. (In Persian).
  4. Boshuizen, H. C., Bongers, P. M., & Hulshof, C. T. (1990). Self-reported back pain in tractor drivers exposed to whole-body vibration. International Archives of Occupational and Environmental Health, 62(2), 109-115. https://doi.org/10.1007/BF00383586
  5. Dahham, G. A., Tawfik, S., & Saleh, S. M. (2019). Practical Study for the Effect of Speed, Direction of Acceleration and Type of Machine on Vibrations Transferred to the Steering Wheel Horticulture Tractor Type (Goldoni). Engineering11(1), 48-58. https://doi.org/10.4236/eng.2019.111005
  6. Faraji, H., Heidarbeigi, K., & Samadi, S. (2021). Characterization of vibration and noise pollution of SI engine fueled with magnetized ethanol–gasoline blends by time–frequency methods. Noise & Vibration Worldwide, 52(11). https://doi.org/10.1177/09574565211030704
  7. Golmohammadi, R. (2010). Noise and Vibration Engineering. (4th ed). Hamadan: Daneshjou Publication. (In Persian).
  8. Iranian National Standard No. 14133. (2011). Agricultural wheeled tractors and farm machineries-Measuring total vibration operator body. (1st ed). (In Persian).
  9. ISO 2631-1. (1997). Mechanical vibration and shock evaluation of human exposure to whole-body vibration, ISO International standard.
  10. Jahanbakhshi, A., Ghamari, B., & Heidarbeigi, K. (2016). Effect of engine rotation speed and gear ratio on the acoustic emission of John Deere 1055I combine harvester. Agricultural Engineering International: CIGR Journal, 18(3), 106-112.
  11. Jahanbakhshi, A., Ghamari, B., & Heidarbeigi, K. (2017). Assessing acoustic emission in 1055I John Deere combine harvester using statistical and artificial intelligence methods. International Journal of Vehicle Noise and Vibration, 13(2), 105-117. https://doi.org/1504/IJVNV.2017.10008785
  12. Jahanbakhshi, A., Ghamari, B., & Heidarbeigi, K. (2020). Vibrations analysis of combine harvester seat in time and frequency domain. Journal of Mechanical Engineering and Sciences, 14(1), 6251-6258. https://doi.org/10.15282/jmes.14.1.2020.04.0489
  13. Jahanbakhshi, A., & Heidarbeigi, K. (2019). Analysis and prediction of noise pollution of garden tractor using statistical methods, artificial intelligence and ANFIS. Iranian Journal of Biosystems Engineering, 50(3), 499-512. (In Persian). https://doi.org/22059/IJBSE.2019.274185.665148
  14. Maleki, A. (2008). Analysis, simulation and evaluation of human and tractor vibration. Ph.D. Dissertation. Mechanical Engineering of Agricultural Machinery. Tehran: University of Tehran. (In Persian).
  15. Melemez, K., Tunay, M., & Emir, T. (2013). The role of seat suspension in whole-body vibration affecting skidding tractor operators. Journal of Food, Agriculture & Environment, 11(2), 1211-1215.
  16. Mohammadi, M., Mirzaee, R., & Ghal Jehi, M. (2009). Investigation of amount of vibration transmitted to the tractor drivers in Zahedan and prevalence of musculoskeletal disorders based on Nordic questionnaire in 2008. Esfahan: 2nd Conference on health, safety and environment; 7-8 October. (In Persian).
  17. Nasiri, P., Beheshti, M. H., & Hajizadeh, R. (2014). Evaluation of exposure time of tiller operators to vibration. Sound and Vibration, 3(6), 66-74. (In Persian).
  18. Nasiri, P., Mohammadi, A., Beheshti, M. H., Azam, K., & Hajizadeh, R. (2013). Evaluation of Massey Ferguson Model 165 Tractor Drivers exposed to whole-body vibration. Journal of Health and Safety at Work, 3(3), 55-62. (In Persian).
  19. Sanai, G., Ghazaee, S., Zia Zarifi, A., & Habibi, A. (1995). Occupational contact limits of pathogens, Ministry of Health and Medical Education, 327-340. (In Persian).
  20. Taghizade Alisaraee, A., Tavakoli Hashjin, T., & Ghobadian, B. (2007). Investigation of vibration of seat of U650 tractor. Iranian Journal of Agriculture Science, 38(4), 571-580. (In Persian).
  21. Taghizade Alisaraee, A. (2011). Investigation of parameters of vibration signal of MF 399 Tractor by diesel and biodiesel fuels. Ph.D. Dissertation. Tehran: Tarbiat Modares University. (In Persian).
  22. Tewari, V. K., Dewangan, K. N., & Karmakar, S. (2004). Operator's fatigue in field operation of hand tractors. Biosystems Engineering, 89(1), 1-11. https://doi.org/10.1016/j.biosystemseng.2004.05.006
CAPTCHA Image