with the collaboration of Iranian Society of Mechanical Engineers (ISME)
Volume 14 (2024)
Volume 13 (2023)
Volume 12 (2022)
Volume 11 (2021)
Volume 10 (2020)
Volume 9 (2019)
Volume 8 (2018)
Volume 6 (2016)
Volume 5 (2015)
Volume 4 (2014)
Volume 3 (2013)
Volume 2 (2012)
Volume 1 (2011)
Research Article
Development of a Grapevine Pruning Algorithm for Using in Pruning

S. M. Hosseini; A. A. Jafari

Volume 7, Issue 2 , 2017, Pages 323-335

https://doi.org/10.22067/jam.v7i2.52617

Abstract
  Introduction Great areas of the orchards in the world are dedicated to cultivation of the grapevine. Normally grape vineyards are pruned twice a year. Among the operations of grape production, winter pruning of the bushes is the only operation that still has not been fully mechanized while it is known ...  Read More

Research Article
Creation Greenhouse Environment Map Using Localization of Edge of Cultivation Platforms Based on Stereo Vision

A. Nasiri; H. Mobli; S. Hosseinpour; Sh. Rafiee

Volume 7, Issue 2 , 2017, Pages 336-349

https://doi.org/10.22067/jam.v7i2.58475

Abstract
  Introduction Stereo vision means the capability of extracting the depth based on analysis of two images taken from different angles of one scene. The result of stereo vision is a collection of three-dimensional points which describes the details of scene proportional to the resolution of the obtained ...  Read More

Research Article
Investigating the Effect of a North Wall on Energy Consumption of an East–West Oriented Single Span Greenhouse

H. Ghasemi Mobtaker; Y. Ajabshirchi; S. F. Ranjbar; M. Matloobi

Volume 7, Issue 2 , 2017, Pages 350-363

https://doi.org/10.22067/jam.v7i2.52534

Abstract
  Introduction Greenhouse is a structure which provides the best condition for the maximum plants growth during the cold seasons. In cold climate zones such as Tabriz province, Iran, the greenhouse heating is one of the most energy consumers. It has been estimated that the greenhouse heating cost is attributed ...  Read More

Research Article
Experimental Investigation of a Solar Greenhouse Heating System Equipped with a Parabolic Trough Solar Concentrator and a Double-Purpose Flat Plate Solar Collector

M. Jafari; H. Mortezapour; K. Jafari Naeimi; M. Maharlooei

Volume 7, Issue 2 , 2017, Pages 364-378

https://doi.org/10.22067/jam.v7i2.56939

Abstract
  Introduction Greenhouses provide a suitable environment in which all the parameters required for growing the plants can be controlled throughout the year. Greenhouse heating is one of the most important issues in productivity of a greenhouse. In many countries, heating costs in the greenhouses are very ...  Read More

Research Article
Study and Evaluation of Ultrasound System for Detecting the Height of Corn Canopy

T. Mesri Gundoshmian; P. Alighaleh; S. Alighale; B. Najafi

Volume 7, Issue 2 , 2017, Pages 379-387

https://doi.org/10.22067/jam.v7i2.48567

Abstract
  Introduction Growth of population, deficiency of resources, environmental hazards, fast spatial science progress and relevant subjects have resulted in significant effects of enhanced accuracy and modern technologies in agricultural technology and management methods. One of the modern technologies’ ...  Read More

Research Article
Remote Sensing of Residue Management in Farms using Landsat 8 Sensor Imagery

M. A. Rostami; H. Afzali Gorouh

Volume 7, Issue 2 , 2017, Pages 388-400

https://doi.org/10.22067/jam.v7i2.50118

Abstract
  Introduction Preserving of crop residues in the field surface after harvesting crops, making difficult farm operations. The farmers for getting rid of crop residues always choose the easiest way, i.e. burning. Burning is one of the common disposal methods for wheat and corn straw in some region of the ...  Read More

Research Article
The Effect of Temperature and Air Velocity on Drying Kinetics of Pistachio Nuts during Roasting by using Hot Air Flow

A. Dini; N. Sedaghat; S. M. A. Razavi; A. Koocheki; B. Malaekeh-Nikouei

Volume 7, Issue 2 , 2017, Pages 401-414

https://doi.org/10.22067/jam.v7i2.55115

Abstract
  Introduction Pistachio nut is one of the most delicious and nutritious nuts in the world and it is being used as a saltedand roasted product or as an ingredient in snacks, ice cream, desserts, etc. The purpose of roasting is to promote flavour and texture changes in nuts that ultimately increase the ...  Read More

Research Article
The Effect of Temperature and Drying Method on Drying Time and Color Quality of Mint

H. Bahmanpour; S. M. Sajadiye; M. J. Sheikhdavoodi; M. Zolfaghari

Volume 7, Issue 2 , 2017, Pages 415-426

https://doi.org/10.22067/jam.v7i2.51268

Abstract
  Introduction Mint (Mentha spicata L.) cbelongs to the Lamiaceae family, is an herbaceous, perennial, aromatic and medicinal plant that cultivated for its essential oils and spices. Since the essential oil is extracted from dried plant, choosing the appropriate drying method is essential for gaining high ...  Read More

Research Article
Investigation on the Ultrasonic Nozzle Parameters Affecting Physical Properties of Tomato Powder

M. R. Arjomandi; M. Aboonajmi; Gh. R. Chegini

Volume 7, Issue 2 , 2017, Pages 427-438

https://doi.org/10.22067/jam.v7i2.53837

Abstract
  Introduction Preserving food products has been much regarded due to the population growth and food scarcity. Drying food is one of the methods of preventing the waste of food products. Spray drying for which products that are initially in the liquid phase is the most suitable method of drying the moisture. ...  Read More

Research Article
Detecting Adulteration in Lotus Honey Using a Machine Olfactory System

M. Hajinezhad; S. S. Mohtasebi; M. Ghasemi-Varnamkhasti; M. Aghbashlo

Volume 7, Issue 2 , 2017, Pages 439-450

https://doi.org/10.22067/jam.v7i2.52910

Abstract
  Introduction Honey is a supersaturated sugar and viscose solution taken from the nectar of flowers, collected and modified by honeybees. Many producers of honey add some variety of sugars in honey that make difficulties with detection of adulterated and pure honey. Flavor is one of the most important ...  Read More

Research Article
Influence of Conservation Tillage on some Soil Physical Properties and Crop Yield in Vetch-Wheat Rotation in Dryland Cold Region

I. Eskandari; V. Feiziasl

Volume 7, Issue 2 , 2017, Pages 451-467

https://doi.org/10.22067/jam.v7i2.50933

Abstract
  Introduction Winter wheat is an important, well-adapted grain crop under dryland condition of the northwest of Iran. Soil water is the most limiting resource for crop growth in dryland areas. Therefore, farmers need to use crop residues and minimum tillage to control the soil erosion and effectively ...  Read More

Research Article Modeling
Modeling and Optimization of Wing Geometry Effect on Draft and Vertical Forces of Winged Chisel Plow

M. R. Salar; S. H. Karparvarfard

Volume 7, Issue 2 , 2017, Pages 468-479

https://doi.org/10.22067/jam.v7i2.52064

Abstract
  Introduction The dynamic response of soil on tillage tools, is an important factor in determining their performance. For a tractor with a certain size, a reduction in draft force, the working width and speed of tools can rise and result in increasing performance and reduce costs. Researches carried out ...  Read More

Research Article
Analytical and Experimental Draft Force Evaluation of Plastic Coated Chisel Tines

M. Barzegar Tabrizi; S. J. Hashemi; R. Karimi

Volume 7, Issue 2 , 2017, Pages 480-490

https://doi.org/10.22067/jam.v7i2.53445

Abstract
  Introduction Improving the efficiency of all agricultural operations has always been important for farmers and engineers. It is well known that the force required for cutting a soil using narrow blades is a function of soil and environmental physical properties, tool shape geometry and the tool’s ...  Read More

Research Article
Ergonomic Evaluation of Vibrations of a Rototiller with New Blade

H. Gholami; D. Kalantari; M. Rajabi Vandechali

Volume 7, Issue 2 , 2017, Pages 491-502

https://doi.org/10.22067/jam.v7i2.56061

Abstract
  Introduction One of the most important problems arising with operation of the conventional rototillers is severe vibration of the machine handle which is transmitted to the user’s hands, arms and shoulders. Long period exposure of the hand-transmitted vibration may cause various diseases such as ...  Read More

Research Article
Comparison of Management-Operational Efficiency of Agricultural Machinery Operating Systems (Case Study Alborz Province)

A. Omidi; M. Almassi; A. M. Borghaee

Volume 7, Issue 2 , 2017, Pages 503-513

https://doi.org/10.22067/jam.v7i2.51782

Abstract
  Introduction Measuring the efficiency of operating systems in comparison with the methods of comparing the performance of systems explains the various dimensions of issues such as, the lack of full use of agricultural machinery capacity, improper selection of machine, incorrect use of machinery, ownership, ...  Read More

Research Article
Identifying and Prioritizing the Effective Parameters on Lack of Timeliness of Operations of Sugarcane Production using Analytical Hierarchy Process (AHP)

N. Monjezi; M. J. Sheikhdavoodi; H. Zaki Dizaji; A. Marzban; M. Shomeili

Volume 7, Issue 2 , 2017, Pages 514-526

https://doi.org/10.22067/jam.v7i2.52521

Abstract
  Introduction Planning and scheduling of farming mechanized operations is very important. If the operation is not performed on time, yield will be reduced. Also for sugarcane, any delay in crop planting and harvesting operations reduces the yield. The most useful priority setting method for agricultural ...  Read More

Research Article
Comparison of Technical and Economical Effect of Different Planters using Varied Seed Rates on Canola Yield in Moghan Region

J. Taghinazhad

Volume 7, Issue 2 , 2017, Pages 527-535

https://doi.org/10.22067/jam.v7i2.42060

Abstract
  Introduction One of the most important agricultural crops is rape seed oil as its special features can play an important role in the agricultural region. Due to the presence of more than 40% oil and 25% protein in the grain can play an important role in the supply of edible oil. After determining of ...  Read More

Research Article
The Effect of Sample Size and Data Numbering on Precision of Calibration Model to predict Soil Properties

H. Mohamadi-Monavar

Volume 7, Issue 2 , 2017, Pages 536-545

https://doi.org/10.22067/jam.v7i2.57501

Abstract
  Introduction Precision agriculture (PA) is a technology that measures and manages within-field variability, such as physical and chemical properties of soil. The nondestructive and rapid VIS-NIR technology detected a significant correlation between reflectance spectra and the physical and chemical properties ...  Read More

Short Paper
Temperature, Humidity and Energy Consumption Forecasting in the Poultry Hall Using Artificial Neural Networknetwork

N. Gholamrezaei; K. Qaderi; K. Jafari Naeimi

Volume 7, Issue 2 , 2017, Pages 546-557

https://doi.org/10.22067/jam.v7i2.50799

Abstract
  Introduction Energy consumption management is one of the most important issues in poultry halls management. Considering the situation of poultry as one of the largest and most developed industries, it is needed to control growing condition based on world standards. The neural networks as one of the intelligent ...  Read More